木絲吸音板安裝方法_secret.doc

一、安裝施工
1、 墻面的安裝
①木龍骨在有木龍骨的情況下，從木絲板的側面即15-25mm厚處斜角釘入普通大鐵釘在
　　　 木龍骨上，板材的正面射槍釘在木龍骨上即可。
備注：木龍骨上要涮防火涂料，以確保全面防火的效果。
　　 ②輕鋼龍骨 在層高較高或防火要求等級較高時，可能不允許使用木龍骨，施工時可
　　　 以用自攻螺絲把小段的木墊片固定在輕鋼龍骨上，然后把吸音板固定在木片上，
　　　 具體施工方法同上①，如果直接安裝在輕鋼龍骨上就需要使用自攻螺釘固定。
　　 ③如果沒有龍骨直接安裝在墻面時，可以使用強力膠直接粘貼，在可能的情況下，
　　　 表面散射槍釘。木基材可以使用白膠加槍釘 。
2、 吊頂的安裝
     ①普通明架、半明架龍骨的安裝方式同礦棉板，龍骨的選擇應當注意板材尺寸(一般為
       600×600mm或600×1200mm)與之相配合，吊筋比普通礦棉板的龍骨稍微密一點。
　　 ②頂部為木龍骨的安裝方式同墻
1, Installation
1, the installation of wall
① wooden keel keel in a wooden case, wood wool board from the side of the angle 15-25mm thick at large nails driven into in the ordinary
Wooden keel on the front panel a gun can be nailed on the wooden keel.
Note: wood keel on fire coating to rinse, to ensure the full effect of fire.
②-storey high metal frame or the fire safety requirements in the higher grades, may not allow the use of wood keel, the construction can be
To use self-tapping screws to short sections of wooden spacer to light steel keel, and then fixed in the wood chips on the sound-absorbing panels,
Concrete construction method Ibid ①, if installed directly on the metal frame on the need to use self-tapping screws.
③ If there is no keel installed directly on the wall, you can use glue directly paste, where possible,
Surface scattering nail gun. You can use white glue wood substrate plus nail gun.
2, the installation of ceiling
     ① General Ming frame, half way out the installation of the keel frame with mineral wool board, keel should be noted that the choice of plate size (usually
       600 × 600mm or 600 × 1200mm) with match, hanging bars than the average density mineral wool board keel a little bit.
② top of the keel for the installation of wood with the wall
 

前往下載