裱糊工程施工工藝標準（938-1996）.doc

9-38 裱糊工程施工工藝標準（938-1996）
1 范圍
本工藝標準適用于工業與民用建筑的內墻面、頂棚等的裱糊工程
2 施工準備
2.1 材料要求：
2.1.1 石膏、大白、滑石粉、聚醋酸乙烯乳液、羧甲基纖維素、107膠或各種型號的壁紙、膠粘劑等。
2.1.2 壁紙：為保證裱糊質量，各種壁紙、墻布的質量應符合設計要求和相應的國家標準。
2.1.3 膠粘劑、嵌縫膩子、玻璃網格布等，應根據設計和基層的實際需要提前備齊。但膠粘劑應滿足建筑物的防火要求，避免在高溫下因膠粘劑失去粘結力使壁紙脫落而引起火災。
2.2 主要機具；
2.2.1 裁紙工作臺、鋼板尺（1m長）、壁紙刀、毛巾、塑料水桶、塑料臉盆、油工到板、拌膩子槽、小輥、開刀、毛刷、排筆、擦布成棉絲、粉線包、小白線、鐵制水平尺、托線板、線墜、盒尺、釘子、錘子、紅鉛筆、砂紙。笤帚、工具袋等。
2.3 作業條件：
2.3.1 混凝土和墻面抹灰已完成，且經過干燥，含水率不高于8%；木材制品
9-38 paper the construction technology standards (938-1996)
1 Scope
This process is applicable within the walls of industrial and civil buildings, such as wall paper roof project
2 construction preparation
2.1 Material Requirements:
2.1.1 Gypsum, hidden, talc, polyvinyl acetate emulsion, carboxymethyl cellulose, 107, or various types of wallpaper glue, adhesive, etc..
2.1.2 Wallpaper: To ensure the quality of wall paper, all kinds of wallpaper, wall fabric quality should meet the design requirements and the corresponding national standards.
2.1.3 adhesives, caulking putty, glass mesh cloth, etc., should be based on the actual design and grassroots get ready in advance. But the adhesive shall meet the building's fire safety requirements, to avoid high temperature due to loss of bond strength to adhesive wallpaper off and cause a fire.
2.2 Main equipment;
2.2.1 trimmer table, plate-foot (1m long), wallpaper knife, towel, plastic bucket, plastic basin, the oil workers to the plate, mixed with putty groove, small roll, knife, brush, brush, rags, into cotton yarn, pink line package, white line, iron spirit level, care line board, the line sinkers, box feet, nails, hammers, red pencil, sandpaper. Broom, tool bags.
2.3 Operating conditions:
2.3.1 Concrete and plaster walls have been completed, and after drying, the moisture content no higher than 8%; wood products
 

前往下載