圓盤鋸的使用安全作業交底.doc
進入下載頁
內容摘要:
1、 操作前應檢查機械是否完好,電器開關等是否良好,保險絲是否符合規格,并檢查鋸片是否有斷和裂的現象,并裝好防護罩,運轉正常后方可投入使用。
2、 操作時,操作者應站在鋸片左的位置,不應與鋸片站在同一直線上,以防木料彈出傷人。
3、 鋸片上方必須安裝保險擋板和滴水裝置,在鋸片后面,離齒10-15cm處,安裝弧形楔刀(松口刀)。
4、 送料不要用力過猛,木料拿平,不要擺動或抬高壓低。
5、 料到盡頭不要用手推按,以防鋸片傷手指。如系兩人操作下手應待木料出鋸臺150mm后,方可去接拉。
6、 鋸短料時,必須用推桿送料。
7、 木料卡在鋸片時,應立即停車后處理。
8、 如發現鋸齒連續斷齒達兩個以上,應進行打磨減少第三齒的繼續損壞。
9、 當鋸片出現裂紋,長度不超過20mm,應在裂紋末端沖止裂孔。
10、嚴禁操作人員在酒后進入施工現場作業。
11、每個工人進入施工現場都必須頭戴安全帽。
12、班組如果因勞力不足需要再招新工人時,應事先向工地報告。
Abstract:
1, the operation should be checked before the machine is intact, electrical switch is good, fuses are standard, and check the saw blade have broken and the crack phenomenon, and install a good protective cover, in normal operation only after put into use.
2, in operation, the operator should stand on the left saw the location, not with the blade on the same straight line, to prevent the wood pop wounding.
3, saw the insurance must be installed above the baffle and drip device, the saw blade back, 10-15cm away from the teeth Department, installed curved wedge knife (relenting knife).
4 Do not feed too much force, timber holding level, do not swing or raise down.
5, pushed by hand do not expect the end to prevent the blade fingers. In the case of the two operations should be lumber start with a 150mm saw Taiwan only after the pick up pull.
6, sawn material must be with his putter feed.
7, wood stuck in the blades should stop immediately after the treatment.
8, as found in serrated teeth up to two or more consecutive off, should be carried out to ascertain the continued reduction of the third tooth damage.
9, when the blade cracks, the length of not more than 20mm, the end should be washed only at the crack hole.
10, prohibited operators in the drink to the construction site work.
11, each worker entering the construction site must be wearing helmets.
12 team if the need to move because of a labor shortage of new workers, the report shall be submitted to the site.
