地下連續墻施工質量技術交底.doc

沖樁班防止偏孔質量技術交底內容:
    根據造成偏孔的原因，在施工過程中采取以下防止措施：
    1、根據甲方所提供的地質資料和相鄰的槽孔的地質情況，及時予知進入巖層的深度、夾層情況以及巖面的坡度，以便采取相應的措施；
    2、保證樁架擺放準確，使錘心正對槽段中心線；加固樁架，減少?zèng)_錘過程中樁架的晃動；
    3、沖錘的直徑控制在80-82CM之內，經常檢查錘牙的磨損程度，及時修補或更換；
    4、沖孔過程中，提錘的高度控制2.5M之內，沖錘撞擊巖面時，保證鋼絲繩仍受拉力，以保持沖錘的豎直；
    5、及時換漿，保持一定的泥漿濃度，防止粘錘；
    6、沖孔至巖土分解面時，低錘密擊，直至進入巖層內部；
     7、加強觀察，發現偏孔及時采取措施予以糾正。
Stone Pile class quality of technical disclosure to prevent the partial hole content:
    According to the reasons causing partial hole in the construction process to take the following preventive measures:
    1, according to the geological information provided by Party A and the adjacent slot of the geological conditions, in a timely manner to know the depth into the rock, mezzanine as well as the slope of rock surface in order to take appropriate measures;
    2 post rack placed to ensure accurate to hammer heart is the center line of the trough section; reinforcement pile frame, reduce the hammer during the rock pile holder;
    3, hammer of the diameter of control within the 80-82CM, regular checks of hammer teeth wear, timely repair or replacement;
    4, punching process, provide a high degree of control 2.5M hammer within the hammer hit rock face, the guarantee still pull rope to keep the hammer in the vertical;
    5, in time for slurry, the slurry to maintain a certain concentration, to prevent sticking hammer;
    6, punching to the decomposition of surface rock, the low-density blow hammer until the rock into the interior;
     7, to enhance observation, found that partial hole to take timely measures to correct.
 

前往下載